Cst Port Configuration - NETGEAR GS748Tv4 Software Administration Manual

3. If you make any configuration changes, click Apply to send the updated configuration to the
switch. Configuration changes take place immediately.
The following table describes the MSTP status information displayed on the Spanning Tree
CST Configuration page.
Field
MST ID
VID
FID
Click Refresh to update the information on the screen with the most current data.

CST Port Configuration

Use the Spanning Tree CST Port Configuration page to configure Common Spanning Tree
(CST) and Internal Spanning Tree on a specific port on the switch.
To display the Spanning Tree CST Port Configuration page, click Switching > STP >
Advanced > CST Port Configuration.
To configure CST port settings:
1. To configure CST settings for a physical port, click PORTS.
2. To configure CST settings for a Link Aggregation Group (LAG), click LAGS.
98 | Chapter 3: Configuring Switching Information
GS748T Smart Switch Software Administration Manual
Description
Table consisting of the MST instances (including the CST) and the
corresponding VLAN IDs associated with each of them.
Table consisting of the VLAN IDs and the corresponding FID associated with
each of them
Table consisting of the FIDs and the corresponding VLAN IDs associated
with each of them.