Http Configuration - NETGEAR GS108T-200NAS Software Administration Manual

HTTP Configuration

Use the HTTP Configuration page to configure the HTTP server settings on the system.
To access the HTTP Configuration page, click the Security tab, then click Access, and then click
the HTTP  HTTP Configuration link.
Figure 5-9
To configure the HTTP server settings:
1. Enable or disable the Web Java Mode. This applies to both secure and un-secure HTTP
connections. The currently configured value is shown when the Web page is displayed. The
default value is Enable.
2. In the HTTP Session Soft Timeout field, specify the number of minutes an HTTP session can
be idle before a timeout occurs.
After the session is inactive for the configured amount of time, the administrator is
automatically logged out and must re-enter the password to access the management interface.
A value of zero corresponds to an infinite timeout. The default value is 5 minutes. The
currently configured value is shown when the Web page is displayed.
3. In the HTTP Session Hard Timeout field, specify the hard timeout for HTTP sessions.
This timeout is unaffected by the activity level of the session. The value must be in the range
of (0–168) hours. A value of zero corresponds to an infinite timeout. The default value is 24
hours. The currently configured value is shown when the Web page is displayed.
Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
5-15