3. Click the appropriate orange bar to expose the available ports or LAGs.
•
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
•
To remove the selected ACL from a port or LAG, click the box directly below the port or
LAG number to clear the selection. An X in the box indicates that the ACL is applied to
the interface.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
5. Click Apply to save any changes to the running configuration.
MAC Binding Table
Use the MAC Binding Table page to view or delete the MAC ACL bindings.
To display the MAC Binding Table, click Security ACL, then click the Basic Binding Table
link.
Figure 5-29
Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
5-49