Port Authentication - NETGEAR GS108T-200NAS Software Administration Manual

Note: If 802.1X is enabled, authentication is performed by a RADIUS server.
• Disable. The switch does not check for 802.1X authentication before allowing traffic on
any ports, even if the ports are configured to allow only authenticated users.
2. Select the appropriate radio button in the Guest VLAN field to enable or disable the guest
VLAN supplicant mode.
• Enabled. When no 802.1X supplicant is authenticated on a port, the port still provides
limited network access, as determined by a guest VLAN configured on the authentication
server.
• Disabled. A guest VLAN cannot be used for unauthorized ports.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
4. If you change the settings, click Apply to apply the new settings to the system.

Port Authentication

Use the Port Authentication page to enable and configure port access control on one or more ports.
To access the Port Authentication page, click Security  Port Authentication, and then click the
Advanced  Port Authentication link.
Note: Use the horizontal scroll bar at the bottom of the browser to view all the fields on
the Port Authentication page.
Port Authentication page.
Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
This means the primary authentication method must be RADIUS. To set
the method, go to Security > Management Security > Authentication
List and select RADIUS as method 1 for defaultList. For more
information, see "Authentication List Configuration" on page
Figure 5-15
v1.0, April 2010
and Figure 5-16 are both images of the
5-13.
5-25