Connecting A Wireless Receiver (Rx101) - Marantz SR7005 User Manual

Connecting an antenna
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Loop
antenna
2
Insert the projecting part
into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Standing alone
Use the procedure shown top to assemble.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
SVENSKA NEDERLANDS
Connecting a wireless receiver
(RX101)
Stand
By connecting a wireless receiver RX101 (sold separately) to this unit,
you can receive and playback audio signals from other devices using
Square
the Bluetooth Communication Function.
hole
• Use a Bluetooth device that is A2DP compatible (vpage 111
Projecting
"A2DP").
part
• You can also use wireless receiver RX101 as an external IR receiver.
• For instructions on the wireless receiver settings, refer to the
RX101's operating instructions.
Nail, tack, etc.
Bluetooth device
(A2DP Compatibility)
You can enjoy listening to music by connecting a wireless receiver
via the M-XPort input connector. In this case, set the input source to
"M-XPort".
NOTE
To use wireless receiver RX101 as external IR receiver, set the
remote sensor function of this unit to "Remote Lock:ON" (vpage 91
"Remote control settings").
ESPAÑOL ITALIANO
Wireless receiver RX101
Remote control unit
FRANÇAIS DEUTSCH ENGLISH
23