Other Settings; Remote Control Settings; Switches Light Illumination On/Off - Marantz SR7005 User Manual

Other settings

Remote control settings

• When you connect a remote control receiver unit (purchased
separately) to the REMOTE CONTROL IN terminal of this unit, use
the following procedure to disable the remote sensor function of
this unit.
• The remote sensor function of remote control signals is enabled by
default.
ON/STANDBY
STATUS
n Disabling the sensor function of the remote
control unit
When the main unit is in standby mode, press
STANDBY STATUS
while holding down
the main unit.
"Remote Lock:ON" is shown on the display, and the infrared light
receiving function is disabled.
n Enabling the remote sensor function
When the main unit is in standby mode, press
STANDBY while holding down STATUS
the main unit.
The infrared light receiving function on the main unit is enabled.
NOTE
If a remote control receiver unit (purchased separately) is not
connected, do not perform this setting. If you do, you will not be able
to operate this unit using the remote control unit.
SVENSKA NEDERLANDS

Switches light illumination on/off

You can switch the lighting around the main display on or off.
• The factory setting is "ON".
Press and hold
• Carry out the same procedure if you want to change the settings
again.
ENTER
ON/
ENTER
and on
ON/
and ENTER on
ESPAÑOL ITALIANO
DISPLAY
DISPLAY
on the main unit for 3 seconds.
FRANÇAIS DEUTSCH ENGLISH
91