Error Messages - Marantz SR7005 User Manual

Error messages

An error message is displayed if Audyssey ® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.
If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
No microphone or Speaker
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ XT
Caution!
Ambient noise is too high
or Level is too low
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Front R None
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Front L Phase
Retry
Skip
RETURN Cancel
Check cause of problem!
Remote control operation
buttons
SVENSKA NEDERLANDS
Error details
• The connected setup microphone is broken,
or a device other than the supplied setup
microphone is connected.
• Not all speakers could be detected.
• The front L speaker was not properly
detected.
• There is too much noise in the room for
accurate measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• The displayed speaker could not be detected. • Check the connections of the displayed
• The displayed is connected with the
polarities reversed.
Move the cursor
(Up/Down/Left/Right)
ESPAÑOL ITALIANO
Measures
• Connect the included setup microphone to
the SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise
or move it away.
• Perform again when the surroundings are
quieter.
• Check the speaker installation and the
direction in which the speakers are facing.
• Adjust the subwoofer's volume.
speaker.
• Check the polarities of the displayed
speaker.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
correct, press ui to select "Skip", then
ENTER
press .
Confirm the setting
FRANÇAIS DEUTSCH
Parameter Check
This function enables you to check the measurement results and
equalizer characteristics after Audyssey Auto Setup.
1
Use to select "Parameter Check" and then
ui
ENTER
press or .
p
2
Use to select the item you want to check, then
ui
press ENTER or .
p
Measurement results for each speaker are displayed.
AUTO SETUP
PARAMETER CHECK
Speaker Config Check
Distance Check
Channel Level Check
Crossover Check
EQ Check
Restore
Show speaker configuration result
Check the speaker configuration.
Speaker Config. Check
Check the distance.
Distance Check
Check the channel level.
Channel Level Check
Check the crossover frequency.
Crossover Check
Check the equalizer.
EQ Check
ui
• If "EQ Check" is selected in step 2, press
curve ("Audyssey" or "Audyssey Flat") to be checked.
Use o p to switch the display between the different speakers.
3
Press RETURN .
The confirmation screen reappears. Repeat steps 2.
Retrieving Audyssey Auto Setup settings
If you set "Restore" to "Yes", you can return to Audyssey Auto Setup
measurement result (value calculated at the start by MultEQ ® XT)
even when you have changed each setting manually.
Return to previous menu
ENGLISH
to select equalizing
11