Installation; Removal - Alpine CDE-W235BT Owner's Manual

2-din cd receiver with advanced bluetooth
Hide thumbs Also See for CDE-W235BT:
Table of Contents

Advertisement

Installation

CAUTION
Do not block the unit's heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
The main unit must be mounted within 30 degrees of the
horizontal plane, back to front.
Less than 30°
1
Remove the mounting sleeve from the main unit (refer to
"Removal" on page 35). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
Mounting Sleeve
Dashboard
(Included)
Pressure Plates*
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
Reinforce the head unit with a metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (
vehicle's chassis.
Connect each input lead coming from an amplifier or equalizer
to the corresponding output lead coming from the left rear of
the CDE-W235BT. Connect all other leads of the CDE-W235BT
according to details described in the CONNECTlONS section.
Heat sink
This unit
Face Plate (Included)
*1
) already attached to the
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
For the screw marked " ", use an appropriate screw for the chosen
mounting location.
3
Slide the CDE-W235BT into the dashboard until it clicks.
This ensures that the unit is properly locked and will not
accidentally come out from the dashboard.

Removal

1
Insert the bracket keys into the unit, along the guides on
either side. The unit can now be removed from the
mounting sleeve.
This unit
2
Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Take the face plate off, and secure the ground lead of the unit to a
clean metal spot using a screw (*) already attached to the car's
chassis.
Attach the Original Mounting Bracket to each side of the
CDE-W235BT, using the screws supplied with CDE-W235BT.
Ground Lead
*
Mounting
Bracket
Chassis
Screw
* 2
Bolt Stud
* 1
This unit
Chassis
Bracket keys
(Included)
Screws (M5 × 8) (Included)
Face Plate (Included)
35
-EN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents