Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 Manual page 422

RapiDeploy Command-line Switches (Continued)
Switch [parameters]
-i[IDnumber]
-ip:[n.n.n.n:p]
-iosize:[n]
-kap
-kp[1-31]
-kprs
Deployment Solution
Details
Function Sets session ID when sending an image file to more
than one computer. Use this switch with multicast sessions so
the Master PC can identify Client PCs in the same session.
Example To send an image to 10 Client PCs, type
[filename]
rdeploy -mdb -f
Note
-i500001 is given as an example. This value is an example of
what the Deployment Server console would send for a session
ID.
See also -m[mode], -s[number of Client
name]
Function Sets the multicast IP address and port. This can be
used for two purposes: 1) To allow multicasting through a router
that is set up to use a different multicast IP address, and 2) to
separate multiple multicasting sessions more efficiently.
If you are manually running multiple multicast sessions, you can
specify a different multicast IP address for each session to allow
the NIC itself to filter out unwanted packets from other sessions.
This speeds up all sessions involved.
Important
Remember to put the port number at the end of the IP address
after a colon.
Example
[filename]
rdeploy -mdb -f
See also -m[mode], -s[number of Client
name]
Function Sets the size in KBytes of reades and writes to the
image file. (4-64k). Default is 32k. If setting this to greater than
32k in DOS, you must use a DOS extender, such as DOS/32A.
Function Prevents rdeploy.exe from overwriting any existing
partitions on the hard disk.
Function (Download only) Prevents rdeploy.exe from
overwriting a specified partition.
n=partition 1 - 31
Example To keep partition 2 from being overwritten during
imaging, type
[filename]
rdeploy -md -f
See also -m[mode], -f[path & file name]
Function Keeps the recovery partition during image restoration.
RapiDeploy Technical Reference
-s9 -i5000001
PCs], -f[path & file
-s9 -ip:224.2.0.3:401
PCs], -f[path & file
-kp2
422