Symantec ALTIRIS DEPLOYMENT SOLUTION 6.9 SP4 - V1.0 Manual page 419

RapiDeploy Command-line Switches (Continued)
Switch [parameters]
-d[hard disk number]
-ddio:[on|off]
-dpos[1-2]
-dsconfig:[filename]
Deployment Solution
Details
Function Specifies which hard disk to read from or write to,
depending on whether you are uploading or downloading. This
switch is used for computers that have more than one hard disk.
Examples
To download an image to disk 2, combine with the
and type
[filename]
rdeploy -d2 -md -f
To create an image from disk 2, combine with the -mu switch
and type
[filename]
rdeploy -d2 -mu -f
See also -m[mode], -f[path & file name]
Disk to Disk
A colon indicates disk-to-disk imaging.
-d1:2 (disk to disk mode, source is disk 1, destination is disk 2)
-d3:2 (Source is disk 3, destination is disk 2)
Linux Software Raid and LVM
When using a Linux software raid or LVM, a comma specifies the
disks in the set.
rdeploy -d1,2 -md -f
If using a hardware raid, this syntax might not be required if the
disk set is recognized as a single drive. Use the
command to determine how the drives are recoginized.
Function Causes RDeploy to bypass the operating system
cache and use direct disk access instead. This can improve
performance in some circumstances. Default is off.
Function Specifies the disk location to set if the imaged disk will
be removed after imaging.
Function Specifies the Deployment Agent configuration file to
copy to the computer when the imaging job completes.
RapiDeploy Technical Reference
[filename]
firm drives
switch
-md
419