Table of Contents
Advertisement
4.2
Fitting the sewing drive
6
4.3
Fitting the pedal
12
8
7
5
–
Attach the sewing drive 2 with its base 1 on the underside of the
table plate.
By screwing the three hexagonal screws (M8x35) with washers
into the table-plate nuts 8.
–
Attach the pedal 4 to the stand brace 3.
–
For ergonomic reasons align the pedal 4 as follows:
The center of the pedal must be approximately under the needle.
There are slots in the stand brace 3 to help align the pedal.
–
Screw the ball pins from the middle to the front hole in the lever 7.
–
Attach pedal linkage 5.
–
Slightly undo screw 6.
–
Adjust the height of the pedal linkage 5 as follows:
when released the pedal 4 should be at an angle of about 10°.
–
Tighten screw 6.
1
2
3
4
4
Advertisement
Table of Contents
