Removing And Fitting The Looper Drive Housing - DURKOPP ADLER 610 Service Instructions Manual

9.1.2 Removing and fitting the looper drive housing

Fig. 28: Removing and fitting the looper drive housing
(1) - Looper drive housing
(2) - Clamping screw
Removing the looper drive housing
1. Tilt the machine backwards ( Section 3.5.1, pg. 11).
2. Loosen the clamping screw (2).
3. Pull the looper drive housing (1) carefully off to the left. While doing so,
Fitting the looper drive housing
1. Push the looper drive housing (1) carefully on to the right. While doing
2. Tighten the clamping screw (2).
Sequence
After installing a completely new looper drive housing, make the following
settings:
• Set the looper drive housing ( Section 9.2, pg. 40)
• Set the needle evasive movement ( Section 9.3, pg. 42)
• Set the symmetry of the looper motion ( Section 9.4, pg. 46)
• Set the looper in the looper mounting ( Section 9.5, pg. 47)
• Set the looper and needle bar height ( Section 9.6, pg. 49)
36
WARNING
Risk of injury
Risk of crushing from moving parts
Switch off the sewing machine before removing or fitting
the looper drive housing.
①
②
slowly turn the lower shaft (3).
so, slowly turn the lower shaft (3) until the rocker bolt is engaged in its
mounting.
Setting the looper
③
(3) - Lower shaft
Service Instructions 610/630 - 00.0 - 10/2014