Fitting The Connecting Cable, Control Panel And Sewing Diode Lamp On The Machine Head - DURKOPP ADLER Lp 2971 Instruction Manual

4.5 Fitting the connecting cable, control panel and sewing diode lamp
on the machine head
1 4
3 6
2
–
The connecting cable (1) is supplied with every machine with the
positioning motor (drive).
–
The control panel (2) had to be ordered separately (optional
equipment). When ordering a control panel, a bracket (3) is always
supplied together with it. The sewing lamp LED (5) is an optional
equipment. Two types of brackets are supplied together with it
to enable the installation of the lighting body in two positions.
Position (5) is the basic one. Position (7) should be used if a guide
for sewing material is mounted on the machine.
–
Dismantle the upper cover and back cover of the machine head.
–
Install the connecting cable with the connector (1) according to the
picture.
–
Install the control panel (2) with the bracket (3) and install the
cable (4) according to the picture.
–
Mount the sewing lamp (5) and install the cable (6) according to the
picture.
–
Push the cables through the table top and attach them with a
self-sticking clip (8).
5
7
8
9
GB
11