Assembling The Stand Components (Long Arm); Assembling The Table Plate; Self-Manufacture Of The Table Top - DURKOPP ADLER 867 - 10-2010 Instruction Manual

3.3

Assembling the stand components (Long arm)

3.4

Assembling the table plate

3.5

Self-manufacture of the table top

–
Assemble the individual stand components as shown in the
illustration.
–
Adjust the set screws 8 to insure the stability of the stand.
Make sure that the stand is safe by insuring that every single foot
of the stand touches the ground.
(867-190040-70, 867-190342-70*, 867-290040-70, 867-392242-70*)
In order to have an optimal arrangement of the components,
please follow the layout.
Stand
MG58 400414
MG58 400404
–
Screw the drawer 10 with its holders onto the left side underneath
the table plate.
–
Screw the oil sump 7 under the table plate.
–
Put the cap 5 into the bore hole of the table plate.
–
Screw the cable duct 4
–
Place the hinge bottoms 12 for the machine head into the cutout
of the table plate and tighten the screws.
–
Insert the rubber corner 2.
–
Attach the table plate 11 to the stand with woodscrews (see
sketch for position).
–
Insert the reel stand 1 in the hole in the table plate and secure it
with the nuts and washers.
Fit and align the yarn-reel and unwinding holders.
The yarn-reel holder and the unwinding arm must be vertically in
line.
–
Screw the holder for the oil-can 9 onto the left-hand stand brace.
* MG58 400414 only available for the above-quoted underclass.
#
Not applicable with sewing machines with direct drive.
If you manufacture the table top yourself, please take the
measurements from the illustrations on pages 43 and 44.
Layout
0791 867716
0791 867715
under the table plate.
#
GB
9