Table of Contents
Advertisement
JUNOSe 11.1.x Physical Layer Configuration Guide
serial description
Configuration Examples
To configure a T3 interface, start at the Global Configuration mode, and issue the
following commands:
To configure an E3 interface, use the controller e3 command in place of the
controller t3 command.
To configure HDLC channels on a T3 serial interface, issue the following commands:
To configure fractional T3 on an interface, issue the following commands:
60
Configuration Examples
Use the no version to restore the default, 1600 bytes.
See mtu.
Use to assign a text description or an alias to a serial HDLC interface.
You can use this command to help you identify the interface and keep track of
interface connections.
The description or alias can be a maximum of 80 characters.
Use the show interfaces serial command to display the text description.
Example
host1(config-if)#serial description boston09 hdlc channel
Use the no version to remove the text description or alias.
See serial description.
host1(config)#controller t3 0/1
host1(config-controll)#no shutdwon
host1(config-controll)#framing c-bit
host1(config-controll)#clock source internal module
host1(config-controll)#cablelength 220
host1#exit
host1(config)#controller t3 10/0
host1(config-controll)#exit
host1(config)#interface serial 10/0
host1(config-subif)#encapsulation ppp
host1(config-subif)#ip address 192.32.10.2 255.255.255.0
host1(config)#controller t3 10/0
host1(config-controll)#dsu mode 0
host1(config-controll)#dsu bandwidth 10000
host1(config-controll)#scramble
Advertisement
Table of Contents
