Example 2: Configuring Interfaces In Sdh Mode; Figure 12: Configuring Fractional E1 And Unframed E1 In Sdh Mode - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

6.
7.
8.
9.

Example 2: Configuring Interfaces in SDH Mode

The following example illustrates how to configure fractional E1 and unframed E1
lines in SDH mode, as shown in Figure 12 on page 143.

Figure 12: Configuring Fractional E1 and Unframed E1 in SDH Mode

1.
2.
3.
Configure an unchannelized T3 on SONET path channel 10.
host1(config-controller)#path 10 ds3 1 unchannelized
Configure a channelized T3 on SONET path channel 12.
host1(config-controller)#path 12 ds3 1 channelized
Configure a T1 channel on the channelized T3 on SONET path channel 12.
host1(config-controller)#path 12 ds3 1 t1 4
Configure two fractional T1 lines on the T3 in path channel 12.
host1(config-controller)#path 12 ds3 1 t1 4/1 timeslots 3-8
host1(config-controller)#path 12 ds3 1 t1 4/2 timeslots 20
Select an OC-12 SONET controller.
host1(config)#controller sonet 4/0
Switch to SDH mode.
host1(config-controller)#sdh
Configure four STM-1 paths. An OC-12 interface has four STM-1 paths.
host1(config-controller)#path 10 stm1 1
Chapter 4: Configuring Channelized OCx/STMx Interfaces
Configuration Examples
143