Configuration Example; Configuring Aps Event Collection - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Physical Layer Configuration Guide

Configuration Example

The following example shows how to configure working and protect interfaces for
APS/MSP.
1.
2.

Configuring APS Event Collection

To configure line modules to deliver APS events to the necessary SNMP traps, issue
the aps events command from Global Configuration mode.
aps events
94
Configuration Tasks
For sd-ber, an integer in the range 5–9; the default value is 5
For sf-ber, an integer in the range 3–5; the default value is 3
Example
host1(config-controll)#threshold sf-ber 4
Use the no version to restore the default, 5 (for sd-ber) or 3 (for sf-ber), for the
specified alarm.
See threshold.
Configure the working interface.
host1(config)#controller sonet 3/0
host1(config-controller)#aps group boston
host1(config-controller)#aps working 1
Configure the protect interface.
host1(config-controller)#controller sonet 3/1
host1(config-controller)#aps group boston
host1(config-controller)#aps protect 0
host1(config-controller)#aps unidirectional
host1(config-controller)#aps revert 30
host1(config-controller)#threshold sf-ber 4
Use to enable line modules to deliver APS events to the necessary SNMP traps.
Use the list variable to deliver the following types of APS events:
all Configure notification of all APS events
channel-mismatch Configure notification of APS channel mismatches
feplf Configure notification of APS far-end protection line failures
mode-mismatch Configure notification of APS mode mismatches
psbf Configure notification of APS protection signal byte failures
switchover Configure notification of APS switchovers