Setting A Baseline; Output Filtering - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Physical Layer Configuration Guide

Setting a Baseline

You can set statistics baselines for serial interfaces, subinterfaces, and circuits using
the baseline interface serial command. You can also set statistics baselines for the
section, line, and path layers using the baseline interface sonet command. Use the
delta options with the show commands to display statistics with the baseline
subtracted.

Output Filtering

You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See Command Line Interface in
JUNOSe System Basics Configuration Guide, for details.
baseline interface serial
baseline line interface sonet
baseline line path interface sonet
154
Monitoring Interfaces
host1#show interfaces serial 2/0:1/1/1/1/1
Use to set a statistics baseline for serial interfaces.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the delta keyword with the show interfaces serial command to view the
baseline statistics.
Example
host1#baseline interface serial 2/0:1/1
There is no no version.
See baseline interface.
Use to set a statistics baseline for the SONET/SDH line layer.
The router implements the baseline by reading and storing the MIB statistics at
the time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the total [ delta ] keywords with the show controllers sonet line command
to view the baseline statistics.
Example
host1#baseline line interface sonet 2/0
There is no no version.
See baseline line interface sonet.