Hdlc Channels; References; Before You Configure An Interface - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

Then assign the timeslots to channel 1, subchannel 1.

HDLC Channels

To identify an HDLC channel or the complete channelized T3 interface, use the format
slot/port:T1 channel/subchannel. Refer to the preceding sections for definitions of the
variables.

References

For more information about channelized T3 interfaces, consult the following resources:
For more information about bit error rate test (BERT) patterns, see:

Before You Configure an Interface

Before you configure a channelized T3 interface, verify the following:
host1(config-controll)#t1 1/1 timeslots 1-4,10,22-24
host1(config-controll)#t1 1/2 timeslots 5-6
host1(config-controll)#t1 1/3 timeslots 7-9
host1(config-controll)#t1 1/4 timeslots 11
host1(config-controll)#t1 1/5 timeslots 12-15,20-21
host1(config-controll)#t1 1/6 timeslots 16-19
RFC 1661 The Point-to-Point Protocol (PPP) (July 1994)
RFC 2495 Definitions of Managed Objects for the DS1, E1, DS2 and E2 Interface
Types (January 1999)
RFC 2495 Definitions of Managed Objects for the DS1, E1, DS2 and E2 Interface
Types (January 1999)
ANSI T1.107a-1990 Standard for Telecommunications Digital Hierarchy –
Supplement to Formats Specification (August 1990)
ANSI T1.403-1989 Standard for Telecommunications Network and Customer
Installation Interfaces – DS1 Metallic Interface – Robbed-bit Signaling State
Definitions (1989)
AT&T Technical Reference 54016 Requirements for Interfacing Digital Terminal
Equipment to Services Employing the Extended Superframe Format (September
1989)
ITU O.151 Error performance measuring equipment operating at the primary
rate and above (October 1992)
ITU O.153 Basic parameters for the measurement of error performance at bit
rates below the primary rate (October 1992)
T1M1.3 Working Group A Technical Report on Test Patterns for DS1 Circuits
(November 1993)
ANSI T1.404-1994 Standard for Telecommunications Network-to-Customer –
DS3 Metallic Interface Specification (1994)
Chapter 1: Configuring Channelized T3 Interfaces
References
9