Move To Another Network (Ipv4); Use The Embedded Web Server; Use The Printer Control Panel - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

NOTE: This procedure resets all TCP/IP parameters. Parameters for other subsystems such as IPX/
SPX or AppleTalk are not affected.
To reset all parameters to factory default values, see
on page 117.

Move to another network (IPv4)

When moving an HP Jetdirect print server that is configured with an IP address to a new network, make
sure that the IP address does not conflict with addresses on the new network. You might need to change
the IP address of the print server, or remove the current IP address and configure another address after
it is installed. See
print server to factory default settings.
NOTE: If you use an HP Jetdirect wireless print server, this section assumes that a wireless network
connection is established.
Moving an HP Jetdirect wireless print server to another network requires a new wireless connection to
that network.
If the current BOOTP server is not reachable, you might configure the print server to use a different
BOOTP server.
If the print server was configured using BOOTP, DHCP, or RARP, update the appropriate system files.
If the IP address was manually set (from the printer control panel or Telnet), reconfigure IP parameters
as described in this chapter.

Use the embedded Web server

You can use the embedded Web server on the HP Jetdirect print server to configure or view IPv4 and
IPv6 parameters. For more information, see

Use the printer control panel

HP Jetdirect EIO or embedded print servers provide a configuration menu that you can open from the
printer's control panel. Using this menu, you can enable or disable network protocols and set basic
network parameters.
NOTE: Control panel configuration support of specific IPv4/IPv6 and IPsec networking parameters
depends on the HP Jetdirect print server and printer.
For instructions about using the control panel for your printer, see your printer documentation.
When accessing the HP Jetdirect menu from the printer's control panel, some TCP/IP network
configuration parameters that you can set include the following (see
(V.38.xx) on page 169
●
IP host name
●
TCP/IPv4 settings
●
TCP/IPv6 settings
●
Other network protocols (IPX/SPX, AppleTalk, DLC/LLC)
58 Chapter 3 TCP/IP configuration
Troubleshoot the HP Jetdirect print server on page 117
for additional parameters):
Troubleshoot the HP Jetdirect print server
Embedded Web server (V.38.xx) on page
for instructions to reset the
61.
HP Jetdirect control panel menus
ENWW