Config Precedence Tab - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Table 4-7 TCP/IP(v6) tab (continued)
Item

Config Precedence tab

Specify the order of precedence of the print server configuration methods. For example, to ensure that
IPv4 parameters configured by a TFTP server cannot be overwritten by a manual configuration method
(such as the printer control panel, Telnet, or embedded Web server), you can indicate that TFTP takes
precedence over manual configuration.
The factory-default precedence order is indicated in the following table.
Table 4-8 TCP/IP Config Precedence tab
Item
Configuration Methods
Reset to default scheme
Reinitialize Now
Clear Previous Values and
Reinitialize Now
Apply
Cancel
Example: To set all parameters configured through DHCP to Read-only, and allow manual configuration
only of parameters that are not configured through DHCP, use the following steps:
1. Turn on the print server so that it obtains its DHCP configuration.
ENWW
Description
Select the Enable check box to use a manually configured IPv6. Clear this check box
to disable the address.
Enter the IPv6 address and its prefix length using the Address and Prefix length fields.
If IPv6 address prefixes (for example, supplied by a router) are stored on the print server,
you can select a prefix from the Prefix field, and then click Add to copy the prefix into
the Address field. Then enter the remainder of the address.
Description
Precedence of the configuration methods. The default precedence order is shown,
where manual configuration has the highest priority. To change the order of the list,
select an entry and use the up or down arrows to move it.
Manual Use the printer control panel, Telnet, embedded Web server, installation and
management software.
TFTP Use a TFTP file from a TFTP server, typically identified during a BootP/DHCP
configuration.
DHCP/Bootp Use a BootP or DHCPv4 server.
DHCPv6 Use a DHCPv6 server.
Default: Factory default configuration.
Reset the precedence table to the default sequence.
Save the new precedence table, clear the configuration method to its factory-default
setting, and restart the IP stack.
Save the new precedence table, clear the configuration method to its factory-default
setting, clear current TCP/IP parameter settings, and restart the IP stack.
Click Apply to save the changes to the Configuration Methods precedence table.
Depending on the changes made, you might need to turn the print server Off/On to
implement.
Click Cancel to cancel your changes to the precedence table.
CAUTION: Clicking Cancel does not reverse changes made by the Reinitialize
Now or Clear Previous Values and Reinitialize Now buttons.
Networking tab 73