View The Embedded Web Server - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

To use the improved security features, HP Web Jetadmin version 8.0 or greater is recommended for
operation with the HP Jetdirect embedded Web server. Using HP Web Jetadmin, you can enable the
IPv4/IPv6 SNMP v3 agent and create an SNMP v3 account on the print server.
NOTE: HP Web Jetadmin 8.0 does not support SNMP configuration over IPv6 protocols. However,
you can view HP Jetdirect MIB configuration objects (such as IPv6 and IPsec objects) over IPv4.
Currently, browser support between HP Web Jetadmin and the embedded Web server might differ. For
supported browsers with HP Web Jetadmin, visit http://www.hp.com/go/webjetadmin.

View the embedded Web server

NOTE: This section assumes that a wireless network connection is established.
If a wireless network connection is not established, you can use the embedded Web server to configure
the HP Jetdirect wireless print server with wireless settings for your network.
Before you can use the embedded Web server, configure the HP Jetdirect print server with an IP
address.
Using IPv6 protocols, addesses are typically configured automatically on the print server, although
manual configuration is available. For basic information on IPv6 addresses, see
on page 15.
Using IPv4 protocols, you can automatically configure IP parameters over the network, using BOOTP
or DHCP each time the print server is turned on. Or, you can manually configure IP parameters using
the printer's control panel (for selected printers), Telnet, the arp and ping commands, HP Web Jetadmin
or other management software. For more information on TCP/IP configuration options, see
configuration on page
When turned on, an HP Jetdirect print server that cannot retrieve a valid IP address from the network
automatically assigns itself either the default IPv4 address 192.0.0.192 or a link-local address in the
range 169.254.1.0 to 169.254.254.255. You can determine the IP address configured on your print
server by inspecting the HP Jetdirect configuration page. See
information.
If the default IPv4 address 192.0.0.192 is assigned, you must temporarily set up your computer with the
same IP network number or establish a route to the print server before you can use the embedded Web
server.
To access the embedded Web server, perform the following steps:
1. Run a supported Web browser.
ENWW
15.
TCP/IP configuration
TCP/IP configuration on page 15
View the embedded Web server
TCP/IP
for more
63