Network Computers Cannot Communicate With The Printer - HP Jetdirect 2700w Setup Manual

Network computers cannot communicate with the
printer
Check the following:
If you previously configured the HP Jetdirect 2700w Print Server with a wireless connection to your
●
network, but the network computers are unable to communicate with the printer, print an
HP Jetdirect configuration page.
The wireless computer must be configured to match the wireless network settings on the
●
HP Jetdirect 2700w Print Server, including:
Communication mode
◦
Network name (SSID) (case sensitive)
◦
Security type
◦
Encryption level, encryption key entries, or the specified transmit key
◦
IP address
◦
BSSID (Basic Service Set Identifier), which distinguishes one wireless LAN from another even
◦
though they have the same SSID
The wireless function is turned on and operating properly (print an HP Jetdirect configuration
●
page).
The computer is within range of the HP Jetdirect 2700w Print Server.
●
If the HP Jetdirect 2700w Print Server is in peer-to-peer mode, there are fewer than six devices
●
total.
If you are initially setting up the HP Jetdirect 2700w Print Server, and the connection fails after
●
entering the configuration settings, reset the print server to factory-default settings (cold reset) and
try again.
ENWW

Network computers cannot communicate with the printer

9