Programmable Heater Setting; Child Lock; Purifire; Sleep Timer - Dimplex MULTIFIRE DF3215 Practical User's Manual

CHILD LOCK

1. Press the ENTER button, the middle display
2. Use the direction buttons on the hand held remote to move the cursor to
ENTER.
3. Press and hold the
child lock function has been turned ON.
4. To turn the child lock function OFF, hold the

PURIFIRE™

The Purifire™ includes a high efficiency filter to help improve the quality of air. When the
Purifire™ function is ON and the Heater
green indicator light is activated on the firebox.
NOTE
The red indicator light overrides the green Purifire™ light.
1. Press the ENTER button until the middle display
2. Press the ENTER button on the
3. Press the left or
4. Press the up direction button to turn the Purifire™ ON, press the down
button to turn the Purifire™ OFF.
5. Press ENTER to return to the main menu.
NOTE
The Purifire™ can also be turned On/Off by pressing the

SLEEP TIMER

The Sleep Timer automatically shuts off the fireplace after a preset time (from 30 minutes to 8
hours).
1. To set the sleep timer press the sleep timer
2. Pressing the sleep timer button repeatedly will increase the sleep timer by 30 minute
increments.
3. The fireplace will automatically turn OFF when the sleep timer reaches 0 minutes.
4. The sleep timer can be cancelled at any time by pressing the sleep timer
repeatedly until the sleep timer display disappears and the room temperature display is
shown.

PROGRAMMABLE HEATER SETTING

The heater thermostat can be programmed to suit your individual needs by using the
INDIVIDUAL DAY SETTING. When going through the programmable heater setting for the
first time the display screen on the remote will read
2 program settings (P1 and P2). Program 1 (P1) is to be used for your comfortable room
setting and Program 2 (P2) is to be used as your set back (energy-saving) temperature. Once
the heater has been programmed and the program has been turned ON the temperature can
only be changed by either turning the program OFF or by pressing the Flame/Heat
button. (see programming individual day setting section to turn program OFF and/or
temporary manual override section)
NOTE
When the occupancy sensor function is ON, it will also override the programmable heater
setting.
up direction button for 4 – 5 seconds. The
icon is NOT displayed on the remote control, the
Purifire™ function.
right direction button to select LOW or HIGH.
flashes.
down direction button for 4 – 5 seconds.
flashes.
Purifire™ On/Off button.
button.
: . The programmable heater has
and press
will flash when the
direction
button
On/Off
11