Configuring Usage Settings - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REFERENCE 10.3 30-03-2010 Reference Manual

Configuring Usage Settings

1 8
There are two ZENworks
enables software usage to be collected and the other setting determines whether usage data is
displayed in the ZENworks Control Center interface or only in software usage reports.
To configure the settings:
1 In the ZENworks Control Center, click the Configuration tab.
2 In the Management Zone Settings panel, click Asset Management to display the settings.
3 Click Usage Monitoring, make sure that the Enable Usage Monitoring option is selected, then
click OK.
If this option is not enabled, no usage statistics are collected from devices.
4 Click Usage Display.
You can decide whether or not to show usage data on License Management pages in ZENworks
Control Center. Displaying usage data can cause the pages to load more slowly while the usage
data is retrieved. For information about where usage data is displayed, see
"Monitoring Usage," on page
5 If you want usage data displayed on the License Management pages in ZENworks Control
Center, deselect the Do not show usage on License Management pages option.
or
If you only want usage data available by generating software usage reports, select the Do not
show usage on License Management pages option.
6 Click OK to save your changes.
®
Management Zone settings related to software usage. One setting
137.
18
Chapter 20,
Configuring Usage Settings 133