Perform Pre-Copy Verifications - Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual

• Show where a folder or object went: Select the object in the left pane, then click Edit > Where
Did It Go. The directory or volume that was moved is highlighted in its new location in the
right pane.
• Show where a folder or object came from: Select the object in the right pane, then click Edit >
Where Did It Come From. The directory or volume that it came from is highlighted in the left
pane.
• Show all folders or objects selected for copying: Select a container in the left pane, then click
Edit > Show Dropped Folders (or Show Dropped Printers).
TIP: The previous six tasks can also be performed by right-clicking the object to see the same
menu option.
• View the available disk space before performing the verification by right-clicking the
destination volume in the right pane of the Project Window and then selecting Properties.
Right-clicking the source folder or volume in the left pane of the Project Window and then
selecting Properties displays the size of the source object.

6.5 Perform Pre-Copy Verifications

After you have dragged-and-dropped the selected directories or volumes and have performed any
other modeling tasks, proceed by clicking Project > Verify and Copy Data or by clicking Do the
Consolidation on the button bar.
NOTE: These instructions assume you have not enabled server-based processing. If you have, refer
to the additional information in
Begin the Verification
1 When the Verification Wizard dialog box displays, click Next to begin the verification process.
2 The Dropped Folders dialog box displays, showing the source path and destination path for the
dropped folders. Do one of the following:
• If the source and destination paths are correct, click Next.
• If the source or destination path is incorrect, click Cancel and make the appropriate
changes in the Project window.
3 (Conditional) If you created new folders in the right pane of the Project window as part of your
consolidation project, the Created Folders dialog box now displays. Do one of the following:
• If the destination path of the created folders is correct, click Next.
• If the destination path is not correct, click Cancel and make the appropriate changes in the
Project window.
4 (Conditional) If you are moving NDPS
Dropped Printers dialog box now displays. Do one of the following:
• If the destination locations of the printers are correct, click Next.
• If the destination locations are not correct, click Cancel and make the appropriate changes
in the Project window.
Section 6.12, "Server-Based Processing," on page
®
printers as part of your consolidation project, the
60.
Consolidating Data from NetWare Servers 45