Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual page 102

3 In the Update Schema dialog box, indicate whether you want the Migration Wizard to update
4 In the Verify Novell Directory Services Tree dialog box, select Yes to acknowledge that the
5 To ensure the security certificate works properly on the destination server, indicate how you
6 (Conditional) If you selected the diskette swap, continue with
102 Novell Server Consolidation and Migration Toolkit Administration Guide
Verify that you have run the DSRepair procedures in
Server for Migration," on page 92
server is functioning correctly.
TIP: If you are required to fix any eDirectory errors, wait approximately 30 minutes for the
eDirectory tree to synchronize before continuing.
the source server's schema and then click Next.
• Yes is the default selection. This causes the Migration Wizard to compare the source and
destination schemas and update the source server's schema to include the eDirectory
classes of the default applications that are installed on the destination server. You must be
logged in as a user with all rights to the [Root] of the tree to make these changes.
• If you do not have the necessary rights to extend the schema, select No. The migration
continues, but you might experience some problems with your eDirectory tree if you skip
this procedure.
source eDirectory tree is healthy (you should have run the DSRepair procedures in
If you select No, the Migration Wizard does not prevent you from continuing. However, if your
tree is unhealthy before you begin the migration, the migration might not complete
successfully.
want to copy the source server's NICI configuration files to the destination server and then
click Next.
To facilitate the NICI file copy, nuwnici.nlm is first copied to both the source and
destination servers. You can choose to copy the NICI files Automatically (over the network) or
using a diskette swap.
automatic copy over the network, skip to
6a To copy the nuwnici.nlm file to the source and destination servers, click Copy NLM
and then click Next.
6b Insert a blank formatted diskette into the floppy drive on the destination server.
6c At the destination server console, enter
load nuwnici -1
6d Remove the diskette from the destination server and insert it into the source server's
floppy drive.
6e At the source server console, enter
load nuwnici -2
This copies the NICI files to the diskette.
6f Remove the diskette from the source server and insert it into the destination server's
floppy drive.
6g At the destination server console, enter
load nuwnici -3
This copies the NICI files to the destination server.
Section 10.2, "Preparing the Source
to ensure that the eDirectory tree containing the source
Step 7.
Step
Step 6a. If you selected the
2).