Installing The Server Consolidation And Migration Toolkit; Meeting The Workstation Requirements - Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual

Table of Contents

Installing the Server Consolidation

and Migration Toolkit

To install the Novell

Server Consolidation and Migration Toolkit, complete the tasks in the

following sections:

•

Section 3.1, "Meeting the Workstation Requirements," on page 27

•

Section 3.2, "Installing the Server Consolidation and Migration Toolkit," on page 28

•

Section 3.3, "Uninstalling the Server Consolidation and Migration Toolkit," on page 29

•

Section 3.4, "What's Next," on page 29

3.1 Meeting the Workstation Requirements

The Server Consolidation and Migration Toolkit runs on a Windows workstation on the network.

This workstation must meet the requirements outlined in this section.

Windows XP Professional Edition or Windows 2000 with Service Pack 3 or later

The utilities in the Toolkit do not run on Windows XP Home Edition, Windows NT, or

Windows 95/98.

NOTE: If you have have Windows XP Professional Service Pack 2, you will see an error

stating that the Server Consolidation and Migration Toolkit software has not been digitally

signed when you run the installation program. You can safely ignore this message and continue

installing the Toolkit.

100 MB of available disk space

Novell Client

4.91 for Windows 2000/XP with the latest Support Pack

To check the Novell Client version, right-click the N icon on the workstation toolbar and then

click Novell Client Properties > Client. To download the latest client, see the

Downloads page

(http://www.novell.com/download).

You must also make the following settings in your Novell Client software:

• Disable file caching

Right-click the N icon, then click Novell Client Properties > Advanced Settings > File

Caching > Setting: Off.

• (Conditional) Enable UTF-8 support if you are copying extended ASCII (multinational

characters) or double-byte character set (oriental languages) data

Right-click the N icon, then click Novell Client Properties > Advanced Settings > Use

UTF8 encoding and NCPs > Setting: On.

• (Conditional) If you are copying data from NetWare

Novell Client software to support the IPX

Windows 2000/XP documentation (http://www.novell.com/documentation/noclienu/

index.html)

for more information.

4 servers, you must configure the

protocol. See the

Novell Client 4.91 for