Table of Contents
Advertisement
8 Select the eDirectory tree that contains your source server, then click Next.
9 Select your source server from the eDirectory tree, then click Next.
10 Select the eDirectory tree that contains your destination server, then click Next.
11 Select your destination server from the destination eDirectory tree, then click Next.
12 To create the project file with the information you have entered thus far, click Create.
Continue with the next section,
11.2 Model Your Migration Project
The Project Window and the Getting Started Migrating from NetWare 5 or 6 window appear after
you have created the migration project file.
If you do not want the Getting Started window to appear the next time you run the Migration
Wizard, deselect Always Show This Window. Click Close to close the Getting Started window and
begin modeling your project.
The Project Window is where you can model different migration scenarios before you begin the
actual migration. To do this, you drag volumes and folders from the left pane (which displays the
source serverr's volumes) and drop them into volumes and folders in the right pane (which shows
the destination server's volumes).
Dragging-and-dropping data in the Project Window does not immediately perform the action. It only
creates a preview of where the data will ultimately reside on the destination server. The data is
copied only after the project verification is complete and the migration process begins.
11.2.1 Working in the Project Window
To begin modeling your migration project, decide what file system data on the source server will be
copied to which volumes and folders on the destination server. You can drag-and-drop entire
volumes or just selected folders from the source server to the destination server.
You can also move created and dropped folders around in the destination pane by dragging them to
the desired location.
Other Project Window Actions
In addition to dragging-and-dropping volumes and folders, you can perform several other tasks in
the Project Window:
• To view a short description of the icons in the Project Window, right-click an object and then
96
Novell Server Consolidation and Migration Toolkit Administration Guide
The filename can be up to 64 characters long and can include any character except \ * ? < > | "
/. It is a good idea to use a standard naming convention to clearly identify each project.
If necessary, click the Login button to attach to the tree.
If necessary, navigate the tree until you find the desired source server.
If necessary, click the Login button to attach to the tree.
If necessary, navigate the tree until you find the destination server. It should be the only server
in the tree.
click What's This?
Model Your Migration
Project.
Advertisement
Table of Contents
Troubleshooting
