Upgrading From Zenworks Configuration Management 10.0.X To Sp3 (10.3); Pre-Upgrade Tasks For Businessobjects Enterprise Server - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT - UPGRADE GUIDE 10.3 30-03-2010 Upgrade Manual

Upgrading from ZENworks
2
Configuration Management 10.0.x
to SP3 (10.3)
This section contains information about upgrading from Novell
Management 10.0.x to ZENworks Configuration Management SP3 (10.3).
To upgrade from ZENworks 10 Configuration Management 10.0.x to ZENworks 10 Configuration
Management SP3 (10.3), devices must meet the requirements described in
in the ZENworks 10 Configuration Management Installation
Because of changes in the ZENworks architecture, ZENworks servers and managed devices cannot
be upgraded from version 10.0.x directly to version 10.3. However, you can use a combination of
ZENworks System Update and the installation media to go from 10.0.x to 10.3.
You cannot use the ZENworks 10 Configuration Management SP3 installation media to upgrade
from version 10.0.x to 10.3. You must follow the directions in this section.
IMPORTANT: Because the upgrade process uses different versions of ZENworks Configuration
Management, you must use different versions of the documentation to perform the upgrade. Ensure
that you follow directions in the appropriate version of each guide referenced below.
Perform the tasks in the following sections to upgrade to ZENworks 10 Configuration Management
SP3:
Section 2.1, "Pre-Upgrade Tasks for BusinessObjects Enterprise Server," on page 15
Section 2.2, "Upgrading to ZENworks Configuration Management 10.3," on page 17
Section 2.3, "Post-Upgrade Tasks," on page 18
2.1 Pre-Upgrade Tasks for BusinessObjects
Enterprise Server
This section is applicable only if BusinessObjects* Enterprise is installed on ZENworks 10
Configuration Management Primary Server. If BusinessObjects Enterprise is not installed on the
ZENworks 10 Configuration Management Primary Server, continue with
ZENworks Configuration Management 10.3," on page
If BusinessObjects Enterprise is installed on the ZENworks 10 Configuration Management Primary
Server, BusinessObjects Enterprise ceases to work when you upgrade the server to ZENworks 10
Configuration Management SP3.

Upgrading from ZENworks Configuration Management 10.0.x to SP3 (10.3)

® ®
ZENworks Configuration
"System
Guide.
Section 2.2, "Upgrading to
17.
2
Requirements"
15