Table of Contents
Advertisement
• If Migration Wizard encounters filenames with a total path length of more than 256 bytes, the
file copy stops. You might need to reorganize the data on your source server if your path
lengths are longer than 256 bytes.
12.5 Data Set Currently In Use Errors in the Error
Log
If you see NWSMTS error: Data set is currently in use and cannot be
accessed errors in the error log file after the migration, it means the specified files were open
during the file copy and were not migrated. You can expect to see these errors for files such as
sys:_swap_.mem and others that are always open. These errors are mainly informational.
12.6 SMDR Errors
Sometimes the SMDR program that is running on the destination server can't make a connection to
the source server. To correct this problem, try one or more of the following:
• Unbind the protocol you are not using from the destination server. For example, if you are
using IP for the migration but IPX is bound on the destination server, unbind the IPX protocol
on the destination server during the migration.
• If Migration Wizard can't load the appropriate tsa.nlm on your destination server, manually
load it from the destination server console and following the onscreen instructions. Or, enter
smdr new at the server console to re-create the SMDR object.
• Load smdr.nlm at the destination server console and then enter smdr new at the destination
server console to solve SMS problems.
• Make sure the latest NLM
Migration Wizard automatically copies the required NLM programs to the source and
destination servers. To verify that you have the latest NLM programs loaded, check the files in
the NetWare Migration Wizard\products\nw3x directory. You might need to load
TSA312 manually.
• Check your primary connections. Right-click the N icon, then select NetWare Connections.
Make sure the destination tree and server are marked as Primary.
• Reboot the source server.
12.7 Restoring Trustees
• If the trustees fail to restore and you get a 0xfffffffb error, this means that you did not modify
your server's IP address in all the necessary places. For more information, see
"Migration Step 2: Edit Configuration Files," on page
• If you need to restore trustees, you can click the Finish NDS/eDir Migration button in the
Migration Wizard, or select Restore Trustees on the toolbar.
12.8 Nuwagent.nlm Load Errors
Nuwagent.nlm is the NLM program that Migration Wizard uses to do much of its work. If you
get errors that the nuwagent.nlm won't load, try the following:
• Manually load nuwagent.nlm at the server console.
programs are loaded on your servers.
TM
Section 11.5,
101.
Troubleshooting Server Migrations 109
Advertisement
Table of Contents
Troubleshooting
