Pc Health Status - JETWAY 694TAS3A User Manual

Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system can not boot. The
settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and
Plug and Play compatible devices. However, this capability means absolutely nothing unless
you are using a Plug and Play operating system such as Windows
to "manual" choose specific resources by going into each of the sub menu that follows this
field (a sub menu is preceded by a ">").
The settings are: Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
DMA Resources
This sub menu can let you control the DMA resource.
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.

3-10 PC Health Status

This section shows the Status of you CPU, Fan, Warning for overall system status. This is
only available if there is Hardware Monitor onboard.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Show PC Health in Post
Vcore
2.5V
3.3V
5V
12V
Current CPU Temp.
Current System Temp.
Current CPUFAN1 Speed
Current CPUFAN2 Speed
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Show PC Health in Post
PC Health Status
Enabled
1.91V
2.50V
3.40V
5.10V
11.95V
33 ° C/91 ° F
21 ° C/69 ° F
5100 RPM
0
F6:Optimized Defaults F7:Standard Defaults
39

95/98. If you set this field
Item Help
Menu Level >
F1:General Help