Agp Function Settings - JETWAY 694TAS3A User Manual

RAS Precharge Time
If an insufficient number of cycles is allowed for the RAS to accumulate its charge before
DRAM refresh, the refresh may be incomplete and the DRAM may fail to retain date. Fast
gives faster performance; and Slow gives more stable performance. This field applies only
when synchronous DRAM is installed in the system. The settings are: Auto, 2 and 3.
Activate To Command Delay
This field let's you insert a timing delay between the CAS and RAS strobe signals, used when
DRAM is written to, read from, or refreshed. Fast gives faster performance; and Slow gives
more stable performance. This field applies only when synchronous DRAM is installed in the
system. The settings are: Auto, 2T and 3T.
RAS Active Time
Select the number of SCLKs for an access cycle. The settings are: Auto, 5T and 6T.
CAS Latency
When synchronous DRAM is installed, the number of clock cycles of CAS latency depends
on the DRAM timing. The settings are: 2 and 3.
DRAM Drive Control
This field let's you choose the Memory Address, Memory Data drive current to suit your
SDRAM Module, the Default setting is Auto.

3-6-2 AGP Function Settings

CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
AGP Rate
AGP Aperture Size
AGP Driving Control
AGP Driving Value
AGP Fast Write
AGP Master 1 WS Write
AGP Master 1 WS Read
↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Note: Change these settings only if you are familiar with the chipset.
AGP Function Settings
Auto
64M
Auto
DA
Disabled
Enabled
Enabled
F6:Optimized Defaults
30
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults