Headers - JETWAY 694TAS3A User Manual

•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.

2-6-2 Headers

USB Port Headers (10-pin block): USB _ B
(1)
These headers are used for connecting the additional USB port plug. By attaching an
option USB cable, your can be provided with two additional USB plugs affixed to the
back panel.
(2) IDE Activity LED: IDELED
This connector connects to the hard disk activity indicator light on the case.
(3) Turbo LED switch: TBLED
Since the motherboard's turbo function is always on. The turbo LED will remain
constantly on while the system power is on. You may wish to connect the Power LED
from the system case to this lead. See the figure below.
(4) Reset switch lead: RESET
This 2-pin connector connects to the case-mounted reset switch for rebooting your
computer without having to turn off your power switch. This is a preferred method of
rebooting in order to prolong the lift of the system's power supply. See the figure
below.
(5) Speaker connector: SPKR
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(6) Power LED: PWR LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(7) Power switch: PW BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
USB _ B
Pin 1
VCC
− DATA
+DATA
G ND
NC
USB Port Headers
18
VCC
− DATA
+DATA
G ND
NC