Table of Contents
Advertisement
Setting Device Properties
7. Click Update to save any changes. If your changes are successfully updated to the Master, the
following message appears. "Network Settings updated. Device must be rebooted for the setting to
take effect".
8. Return to the System menu by clicking on the purple System icon (within the Online Tree), click the
Reboot button, and then allow the Master a short time to reboot itself.
9. Click on the Refresh macro from the browser's menu bar. If no security is currently enabled on the
target Master, you are directed back to the Manage WebControl Connections page. If security is
enabled, you are directed to the initial Username/Password page to enter your access information.
Step 3: Change the System Number via the System Menu
1. Click the Manage System link (from within the System Settings section of the Navigation frame).
2. Click on the purple System icon from within the Online Tree to open the System menu buttons
within the right frame.
3. Click the System Number button to open the Change System Number dialog. This dialog shows
the current system number (read-only) on the target Master.
4. Enter a new numeric value into the New Device Number field.
5. Click the Update button to save this new value to the device. The following message; "Device
number changed to XXX. Device must be rebooted for the change to take effect.", reminds the user
that the Master must first be rebooted before the new settings take effect.
Step 4: Reboot the Master via the System Menu
1. Click the Manage System link (from within the System Settings section of the Navigation frame).
2. Click on the purple System icon (within the Online Tree) to open the System menu buttons within
the right frame.
3. Click the Reboot button to remotely reboot the target Master. No dialog appears while using this
button. The Online Tree then reads "Rebooting...". After a few seconds, the Online Tree refreshes
with the current system information (showing the newly updated system number).
If the Online Tree contents do not refresh within a few minutes, press the browser's Refresh button
and reconnect to the Master.
Modero Touchpanels Device Addressing
1. Press the grey Front Setup Access button for 3 seconds to open the Setup page
2. Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected
Setup page and display an on-screen keypad.
3. Enter 1988 into the Keypad's password field and press Done when finished.
4. Press the red Device Number field to open the Device Number keypad.
5. Enter the Device Number value for the panel into the Device Number Keypad.
6. Press Done to close the keypad, assign the number, and return to the Protected Setup page.
7. Press the on-screen Reboot button to restart the panel and incorporate any changes.
88
CONFIDENTIAL AND PROPRIETARY. COPYRIGHT, AMX LLC, 2006
VisualArchitect v1.1
Advertisement
Table of Contents
Troubleshooting
