Adjust Tonal Quality For Each Speaker Using Graphic Equalizer (Manual; Restoring Compressed Audio To Nearly Pre-Compressed Conditions For Playback (Restorer); Adjusting The Audio Delay Time While Watching The Picture (Audio Delay) - Denon 2310CI - AVR AV Receiver Owner's Manual

ENGLISH
Adjust Tonal Quality for Each Speaker Using Graphic
Equalizer (Manual EQ)
Setting items
Adjust CH
1. Select speaker adjustment method.
All CH : Adjust tonal quality for all speakers together.
Adjust the tonal quality of
L/R CH : Adjust tonal quality for each L/R speaker pair.
the individual speakers.
Each CH : Adjust tonal quality for each speaker separately.
2. Select the frequency band to be adjusted.
63Hz / 125Hz / 250Hz / 500Hz / 1kHz / 2kHz / 4kHz / 8kHz /
16kHz
b When "L/R CH" or "Each CH" is selected, select the speaker to be
adjusted.
3. Adjust the level.
–20.0dB ~ +6.0dB (0dB)
Base Curve Copy Yes : Copy.
Copy MultEQ ® "Audyssey
No : Do not copy.
Flat" correction curve.
"Base Curve Copy" is displayed after Audyssey Auto Setup procedure
has been performed.
Default Yes : Reset to the defaults.
No : Do not reset to the defaults.
Reset the "Manual EQ"
settings to their defaults.
Remote control
0
operation buttons
Default settings are underlined.
Setting contents
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Adjusting the Sound and Picture Quality (Audio/Video Adjust)
Restoring Compressed Audio to Nearly Pre-compressed
Conditions for Playback (RESTORER)
• Such compressed audio formats as MP3, WMA (Windows Media Audio) and MPEG-4 AAC reduce the
amount of data by eliminating signal components that are hard for the human ear to hear. The RESTORER
function generates the signals eliminated upon compression, restoring the sound to conditions near
those of the original sound before compression. It also corrects the sense of volume of the bass to obtain
richer sound with compressed audio signals.
• This can be set with analog signals or when a PCM signal (fs = 44.1/48 kHz) is input.
Setting contents
OFF : Do not use RESTORER.
Mode1 (RESTORER 64) : Optimized mode for compressed sources with very weak highs.
Mode2 (RESTORER 96) : Apply suitable bass and treble boost for all compressed sources.
Mode3 (RESTORER HQ) : Optimized mode for compressed sources with normal highs.
• The default setting for "iPod" is "Mode3" . All others are set to "OFF" .
• W hen set to something other than "OFF" , "
• This can also be set by pressing during playback.
OFF
(RESTORER 64)
(RESTORER HQ)
Adjusting the Audio Delay Time while Watching the
Picture (Audio Delay)
Setting contents
0ms 200ms
~
• If you wish to adjust the "Audio Delay" while playing HDMI or component video signals, press
to set "GUI" to "OFF" . This way the audio delay can be adjusted while watching the picture. (Press
the u again. The display switches to the display of the menu screen only.)
• This cannot be adjusted when playing in the EXT. IN, DIRECT or STEREO mode (with "Front
Speaker" set to "Large" , "Tone Control" to "OFF" and "MultEQ" and "RESTORER" to "OFF").
• When the Auto Lipsync Correction function is operating, you can set within the range 0 ~ 100 ms.
• Store "Audio Delay" for each input source.
: Decision the setting
Default settings are underlined.
" is displayed.
Mode 1 Mode 2
(RESTORER 96)
Mode 3
Default settings are underlined.
: Return to previous menu
u