Wireless Statistics; Dhcp - TP-Link TL-MR3040 User Manual

TL-MR3040
6.6.5

Wireless Statistics

Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission
information in the following screen shown in Figure 6-17.
Figure 6-17 Statistics of the device attached wireless stations
Operation Mode - Shows the current operation mode. If Multi-SSID is selected, all
connected wireless stations will be shown here
MAC Address - Shows the connected wireless station's MAC address
Current Status - The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected
Received Packets - packets received by the station
Sent Packets - packets sent by the station
You cannot change any of the values on this page. To update this page and to show the current
connected wireless stations, click the Refresh button.
If the numbers of connected wireless stations go beyond one page, click the Next button to go
to the next page and click the Previous button to return the previous page.
Note:
This page will be refreshed automatically every 5 seconds.

6.7 DHCP

DHCP stands for Dynamic Host Configuration Protocol. The DHCP Server will automatically
assign dynamic IP addresses to the computers on the network. This protocol simplifies network
management and allows new wireless devices to receive IP addresses automatically without
the need to manually assign new IP addresses.
There are three submenus under the DHCP menu (shown as Figure 6-18): DHCP Settings,
DHCP Clients List and Address Reservation. Clicking any of them will enable you to
Portable 3G/3.75G Battery Powered Wireless N Router
-202-