Audio Adjust - Onkyo NR3007 - TX AV Network Receiver Instruction Manual

Advanced Setup—Continued

Audio Adjust

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [ ]/[ ] buttons to
select "3. Audio Adjust", and then press
[ENTER].
3
Use the Up and Down [ ]/[ ] buttons to
select the submenu, and then press
[ENTER].
Multiplex/Mono
Multiplex
Input Channel
This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or
languages with multiplex sources, multilingual TV broadcasts, and so on.
Mono
Input Channel
This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or
2-channel analog/PCM source in the Mono listening mode.
Output Speaker
This setting determines which speakers output mono audio when the Mono listening mode is selected.
Note:
If the "Center" setting is set to "None" (page 95), this setting is fixed at "Left / Right".
Dolby
PLIIx Music (2ch Input)
These settings apply to only 2-channel stereo sources.
If you're not using any surround back speakers, these settings apply to Dolby Pro Logic II, instead of Dolby Pro
Logic IIx.
Panorama
With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx
Music listening mode.
Dimension
With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music
listening mode. Higher settings move the sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there's too much surround sound, move the sound field forward to improve
the balance. Conversely, if the stereo image feels like it's in mono, or there's not enough surround sound, move
it backward.
100
Main: The main channel is output (default).
Sub: The sub channel is output.
Main/Sub: Both the main and sub channels are output.
Left + Right: Both the left and right channels are output (default).
Left: Only the left channel is output.
Right: Only the right channel is output.
Center: Mono audio is output by the center speaker (default).
Left / Right: Mono audio is output by the front left and right speakers.
On: Panorama function on.
Off: Panorama function off (default).
–3 to +3 (default: 0)
4
Use the Up and Down [ ]/[ ] buttons to
select setting, and then use the Left and
Right [ ]/[ ] buttons to set them.
5
When you've finished, press the [SETUP]
button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.