Using The Remote Controller In Zone 2/3 And Multiroom Control Kits - Onkyo NR3007 - TX AV Network Receiver Instruction Manual

Multi Zone—Continued
Using the Remote Controller in Zone
2/3 and Multiroom Control Kits
To control the AV receiver with the remote controller
while you're in Zone 2 or Zone 3, you'll need a commer-
cially available multiroom remote control kit for each
zone.
• Multiroom kits are made by Niles and Xantech.
These kits can also be used when there isn't a clear line
of sight to the AV receiver's remote sensor, such as when
it's installed inside a cabinet.
Using a Multiroom Kit with Zone 2/3
In this setup, the IR receiver in Zone 2/3 picks up the
infrared signals from the remote controller and feeds
them through to the AV receiver in the main room via the
connecting block.
IR IN
Connecting
block
Main room
Signal flow
The miniplug cable from the connecting block should be
connected to the AV receiver's IR IN jack, as shown
below.
Miniplug cable
AV receiver
138
IR receiver
Remote controller
Zone 2/3
From the connecting block
Signal flow
Using a Multiroom Kit with a Cabinet
In this setup, the IR receiver picks up the infrared signals
from the remote controller and feeds them to the AV
receiver located in the cabinet via the connecting block.
Connecting
block
IR IN
Inside
cabinet
Signal flow
Using a Multiroom Kit with Other
Components
In this setup, an IR emitter is connected to the AV
receiver's IR OUT jack and placed in front of the other
component's remote control sensor. Infrared signals
received at the AV receiver's IR IN jack are fed through
to the other component via the IR emitter. Signals picked
up by the AV receiver's remote control sensor are not
output.
Connecting
block
IR IN
AV receiver
IR OUT
IR Emitter
Other component
Signal flow
The IR emitter should be connected to the AV receiver's
IR OUT jack, as shown below.
Miniplug cable
Miniplug
AV receiver
Signal flow
IR receiver
Remote controller
IR receiver
Remote controller
Other component
Remote control
sensor
Emitter
IR Emitter