Onkyo NR3007 - TX AV Network Receiver Instruction Manual page 108

Advanced Setup—Continued
*2
Resolution
You can specify the output resolution for the HDMI outputs and have the AV receiver upconvert the picture
resolution as necessary to match the resolution supported by your TV.
Available only when "Source" has been selected in the "Resolution" of the "Monitor Out" setting (page 53).
*2
Brightness
With this setting you can adjust the picture brightness. "–50" is the darkest. "+50" is the brightest.
*2
Contrast
With this setting you can adjust contrast. "–50" is the least. "+50" is the greatest.
*2
Hue
With this setting you can adjust the red/green balance. "–20" is the strongest green. "+20" is the strongest red.
*2
Saturation
With this setting you can adjust saturation. "–50" is the weakest color. "+50" is the strongest color.
*2
Gamma
Adjust the balance of incoming picture R (red), G (green), and B (blue) color data signal to the output color
data signal.
Red Brightness
With this setting you can adjust the picture red brightness. "–50" is the darkest. "+50" is the brightest.
Red Contrast
With this setting you can adjust red contrast. "–50" is the least. "+50" is the greatest.
Green Brightness
With this setting you can adjust the picture green brightness. "–50" is the darkest. "+50" is the brightest.
Green Contrast
With this setting you can adjust green contrast. "–50" is the least. "+50" is the greatest.
Blue Brightness
With this setting you can adjust the picture blue brightness. "–50" is the darkest. "+50" is the brightest.
Blue Contrast
With this setting you can adjust blue contrast. "–50" is the least. "+50" is the greatest.
Notes:
*2 When the "ISF Mode" setting is set to "Day" or "Night", this setting cannot be selected.
108
Through: Select this to pass video through the AV receiver at the same resolution
and with no conversion (default).
Auto: Select this to have the AV receiver automatically convert video at
resolutions not supported by your TV. When the "Monitor Out" is set to
"Analog", this setting will be changed to "Through".
480p (480/576p):
Select this for 480p or 576p output and video conversion as necessary.
720p: Select this for 720p output and video conversion as necessary.
1080i: Select this for 1080i output and video conversion as necessary.
1080p: Select this for 1080p output and video conversion as necessary. When
the "Monitor Out" is set to "Analog", this setting will be changed to
"1080i".
1080p/24: Select this for 1080p output at 24 frames per second and video
conversion as necessary. When the "Monitor Out" is set to "Analog",
this setting will be changed to "1080i".
–50 to +50 (default: 0)
–50 to +50 (default: 0)
–20 to +20 (default: 0)
–50 to +50 (default: 0)
–3 to +3 (default: 0)
*2 –50 to +50 (default: 0)
*2
–50 to +50 (default: 0)
*2 –50 to +50 (default: 0)
*2 –50 to +50 (default: 0)
*2 –50 to +50 (default: 0)
*2 –50 to +50 (default: 0)