Connecting Onkyo Components; Connecting The Power Cord - Onkyo NR3007 - TX AV Network Receiver Instruction Manual

Connecting the AV receiver—Continued
Connecting Onkyo
Step 1:
Make sure that each Onkyo component is connected
to the AV receiver with an analog audio cable (con-
nection in the hookup examples) (see pages 35 to
a
44, 46).
Step 2:
Make the connection (see illustration right).
Step 3:
If you're using an MD, CDR, or RI Dock, change the
Input Display (see page 60).
With (Remote Interactive), you can use the follow-
ing special functions:
■ Auto Power On/Standby
When you start playback on a component connected
via , if the AV receiver is on Standby, it will auto-
matically turn on and select that component as the
input source. Similarly, when the AV receiver is set
to Standby, all components connected via
also go on Standby.
■ Direct Change
When playback is started on a component connected
via , the AV receiver automatically selects that
component as the input source.
■ Remote Control
You can use the AV receiver's remote controller to
control your other -capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(see page 142).
Notes:
• Use only cables for
are supplied with Onkyo players (DVD, CD, etc.).
• Some components have two
nect either one to the AV receiver. The other jack is for
connecting additional
• Connect only Onkyo components to
necting other manufacturer's components may cause a
malfunction.
• Some components may not support all
Refer to the manuals supplied with your other Onkyo
components.
• While Zone 2 or Zone 3 is on, the Auto Power
On/Standby and Direct Change
work.
Components
will
connections. cables
jacks. You can con-
-capable components.
jacks. Con-
functions.
functions do not
REMOTE
CONTROL
e.g., CD player
e.g., DVD player

Connecting the Power Cord

Notes:
• Before connecting the power cord, connect all of
your speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different branch circuit.
• Do not use a power cord other than the one supplied
with the AV receiver. The supplied power cord is
designed exclusively for use with the AV receiver and
should not be used with any other equipment.
• Never disconnect the power cord from the AV receiver
while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first, and then
the AV receiver.
Step 1:
Connect the supplied power cord to the AV receiver's
AC INLET.
Step 2:
Plug the power cord into an AC wall outlet.
IN
L
R
CD
IN
L
R
DVD/BD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
To AC wall outlet
47