Getting ready to Embroider
1
1
2
3
Winding the bobbin
Guide the thread around the bobbin winder thread guide while
holding the thread at the spool.
1.
Bobbin winder thread guide
Thread through the hole in the bobbin from the inside to the
outside. Put the bobbin on the bobbin winder spindle.
2
Bobbin winder spindle
Push the spindle to the right. Press the Start/Stop button while
holding the end of the thread. Stop the machine after the bobbin
has made a few turns. Cut the thread close to the hole in the
bobbin. Press the Start/Stop button again. When the bobbin is fully
wound it will stop automatically. Press the Start/Stop button to stop
the machine then return the bobbin winder spindle to the left.
Remove the bobbin and cut the thread with the bobbin thread
cutter.
3.
Bobbin thread cutter
Notes:
Do not move the bobbin winder spindle while the machine is
running. For safety purposes, the motor will stop automatically after
running for two minutes.
Adjust how much the bobbin is filled by rotating the bobbin winder
stopper.
To achieve the best embroidery quality, BERNINA recommends to use
only high quality bobbin thread such as OESD 41ET/W or Mettler ®
9