Table of Contents
Advertisement
Embroidery preparation
> Pull the loop of thread (14) to the rear until the end of the thread is pulled through the needle.
14
> Pull the thread below the presser foot and through to the thread cutter (15), and cut it.
15
Winding the bobbin thread
The bobbin thread can be wound while embroidering if the retractable spool pin is used for winding.
Prerequisite:
•
The foam pad, the thread spool and the appropriate thread disc are positioned.
> Attach the empty bobbin on the winding unit so that the silvery sensor surface is down.
> Guide the thread to the left into the rear thread guide (1).
> Guide the thread around the thread pretension clockwise (2).
> Wind the thread clockwise 2 to 3 times around the empty bobbin (3).
39
Advertisement
Table of Contents
