Table of Contents
Advertisement
3
1
2
1
6
STARTING POIN T FOR MONOGRAMMIN
G
CENTER POINT
6
Getting Ready to Embroider
4
3
2
4
7
9
8
5
7
8
5
Your embroidery computer can handle almost every materials
commonly used. However, to achieve best embroidery results it is
important to use the correct materials and tools for your project.
The next pages will give you a short overview of the most important
rules to make this choice. For more detailed informations please
contact your BERNINA dealer or read specific technical literature.
Embroidery Hoop
The Deco 340 is supplied with two hoops. Use hoop A for regular
designs up to 126 x 110 mm (5" x 4
accommodate a large design up to a 200 x 140 mm (8" x 5
1.
Outer hoop
2.
Inner hoop
3.
Attaching knob
4.
Hoop tightening screw
Please see your BERNINA dealer for additional hoop sizes. The
following hoops are preset in the embroidery computer:
Hoop C: for free arm embroidery, 50 x 50 mm
Hoop F: round, embroidery area 126 x 110 mm
Templates
When positioning the fabric into the hoop, use the template to align
the centerlines on the fabric with the center of the hoop. First mark
the centerlines on the fabric and place the fabric on the outer hoop.
Place the inner hoop and template over the fabric and adjust the
fabric placement.
5.
Starting point for built-in designs and Embroidery
cards.
6.
Starting point for monogramming in horizontal
placement
7.
Starting point for monogramming in vertical
placement
8.
Finger hole
Note:
The four indentations on the template do not correspond with the
reference lines.
9.
Positioning indentations
9
17
3
"), while the hoop B will
/8
1
").
/2
Hide quick links:
Advertisement
Table of Contents
