Table of Contents
Advertisement
> Thread the 3 threads up to the upper thread guide.
> Guide 2 threads (vertical spool pin) past the thread tension disc (1) on the left and up to the thread guide
above the needle.
> Guide 1 thread (horizontal spool pin) past the thread tension disc (1) on the right and up to the thread
guide above the needle.
> Thread 1 thread of the vertical thread spool pin into the left and right needle by hand.
> Thread the thread of the horizontal spool pin into the center needle manually.
Winding the bobbin thread
The bobbin thread can be wound while embroidering if the swiveling spool holder is used for winding.
Prerequisite:
•
The foam pad, the thread spool and the appropriate spool disc are fitted.
> Place the empty bobbin on the Winding Unit (1) so that the silvery sensor surface is down.
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the bobbin winder pretension clockwise (3).
> Wind the thread clockwise 2 – 3 times around the empty bobbin (4).
2
3
> Pull the excess thread over the thread cutter at the engaging lever (5) and cut.
1
4
5
Sewing Preparation
45
Advertisement
Table of Contents
