Verify - Cisco AS5300-96VOIP-A Software Configuration Manual

Configuring MMP
Table 3-29
Step
11
12
13
1. A virtual template is a serial interface configuration with no hardware association.
2. DHCP = Dynamic Host Configuration Protocol.

Verify

To verify the MMP configuration on each server:
•
Tips
If you are having trouble:
•
3-56 Cisco AS5300 Universal Access Server Software Configuration Guide
Configuring MMP (Continued)
Command
5300(config-if)# ppp multilink
5300(config-if)# ppp authentication chap
5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Enter the show sgbp command:
5300# show sgbp
Group Name: test Ref: 0x4780B252
Seed bid: default, 50, default seed bid setting
Member Name: 5300-3 State: active Id: 9
Ref: 0x4780B54D
Address: 172.22.21.8
5300# show sgbp
Group Name: test Ref: 0x4780B54D
Seed bid: default, 50, default seed bid setting
Member Name: 5300-7 State: active Id: 1
Ref: 0x4780B252
Address: 172.22.21.12
Note the following:
— Check to make sure State is active. State set to idle indicates there is a misconfiguration on
either side.
— Check to make sure the username and password are configured for the sgbp group; otherwise
the servers will not be able to talk to each other.
Enter the debug sgbp ? command to view a list of available debugging commands:
5300# debug sgbp ?
errors SGBP errors
events SGBP events
hellos SGBP connection hellos
messages SGBP messages
queries SGBP mastership queries
Purpose
Enable Multilink PPP on the virtual
template interface.
Enable PPP authentication on the virtual
template interface.
Return to enable mode.
This message is normal and does not
indicate an error.