Creating Authentication Accounts - Cisco AS5300-96VOIP-A Software Configuration Manual

•
•

Creating Authentication Accounts

You can create authentication accounts for other routers in an MMP stack. If your stack name is
STACK1, you need to create a user account called STACK1 on each router with the same password.
Enter the debug sgbp errors command to view error messages. When you finish viewing the
messages, enter the no debug sgbp errors to turn off the messages.
5300# debug sgbp errors
*Mar 4 11:55:24.105 EST: %SGBP-1-MISSCONF: Possible misconfigured member 5300-6 using
172.22.21.11
*Mar 4 11:55:41.185 EST: %SGBP-7-NORESP: Fail to response to 5300-3 group test, may
not have password
Error messages are displayed if one server 5300-6 shows an sgbp group configured but the group
is not configured for another server in the group. Error messages are also displayed if the
password is not configured for the sgbp group.
Enter the debug sgbp events command to view event messages. When you finish viewing the
messages, enter the no debug sgbp events to turn off the messages.
5300# debug sgbp events
*Mar 4 12:26:46.441 EST: %SGBP-7-CLOSE: Closing pipe for member 5300-3
*Mar 4 12:26:46.445 EST: %SGBP-5-LEAVING: Member 5300-3 leaving grouptest
The above event message indicates that the sgbp connection went down and 5300-3 is no longer
part of the 5300-7 sgbp group. You can check 5300-3 for the reasons why the sgbp connection
went down. Possibly, the sgbp member entry for 5300-7 was removed or there is no
communication between 5300-7 and 5300-3.
username STACK1 password cisco
sgbp group STACK1
sgbp member other_router_name other_router_IP_address
Creating Authentication Accounts
Basic Configuration 3-57