Table of Contents
Advertisement
Tips
If you are having trouble downloading the voice feature card software in VCWare mode, try the
following:
•
•
After you have completed the preceding tasks, reboot the Cisco AS5300 for these changes to take
effect.
Download Software in ROM Monitor Mode
Use the steps in the following table to download new voice software if your voice card is running in ROM
Monitor mode from a floppy diskette. To do so, first copy the software from the floppy diskette to a TFTP
server. After the software is on the TFTP server, begin the steps in the following Configure section.
Configure
Step
1
2
3
4
5
6
Run the show vfc slot_number board command to verify that the voice feature card is back up
in VCWare mode.
5300# show vfc 1 board
VFC board state is UP, vfc status VCWARE running(0x4)
VFC board in slot 1 with 18 dsps
5300#
Determine if the
VFC ROM version you are running is 1.1 or version1.2.
Command
5300# clear vfc slot_number purge
clear vfc <slot# cons flash erase
5300# copy tftp: vfc:
Voice card slot number <slot ? 1>
Address or name of remote host [UNKNOWN]?
223.255.212.244
Source file name? vcware.vcw
Destination file name [vcware.vcw]? vcware.vcw
! note, the destination filename is *IMPORTANT*
Accessing file 'vcware.vcw' on 223.255.212.244...
Loading vcware.vcw from 223.255.212.244 (via
Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 291292/291328 bytes]
[OK - 291292/291292 bytes]
5300> clear vfc slot_number
5300> enable
Password: <password>
5300#
5300# show vfc slot_number board
5300#
5300# show vfc slot_number directory
5300#
Download Software in ROM Monitor Mode
Purpose
Erase the contents of the VFC Flash in
the selected voice card. This may take
awhile.
Use TFTP to download the new images
to VFC Flash memory.
If the VFC ROM version is 1.1 the
Note
image name must end with the extension
".VCW" (all uppercase). If the VFC
ROM is version 1.2, the image name
must begin with "vcw-" (all lowercase)
and no other character can be in front of
the "vcw-", so no directory path should
be prepended to the image name.
Reboot the voice feature card so you can
add the new VCWare image into the
voice card.
Re-enter enable mode.
Enter the password.
You have entered enable mode when the
prompt changes to
5300#
Check to see if the VFC is back up in
ROM monitor mode.
Verify that VCWare is in the VFC Flash.
Upgrade VoIP Software D-5
.
Advertisement
Table of Contents
