Table of Contents
Advertisement
Configuring Channelized T1 or E1
Configuring Channelized T1 or E1
Configure the access server for channelized T1 or E1 lines.
Configure
Note
controllers 1 to 7 as secondary clocks. (Synchronized clocking is necessary throughout the network
for reliable data transmission.) The secondary clock sources serve as backups in case of the primary
clock failure. You can change the clock source using the clock source line primary and clock
source line secondary <1-7>.
Table 3-7
Step
1
2
3
4
5
6
7
Verify
To verify your controller is up and running and no alarms have been reported:
•
3-10
Cisco AS5300 Universal Access Server Software Configuration Guide
By default, synchronized clocking is set with controller 0 as the primary clock source and
Configuring Channelized T1 or E1
Command
5300> enable
Password: <password>
5300#
5300# configure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
5300(config)# controller t1 0
5300(config-controller)#
5300(config-controller)# framing esf
5300(config-controller)# linecode ami
5300(config-controller)# controller t1 X
5300(config-controller)# framing esf
5300(config-controller)# linecode ami
5300(config-controller)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Enter the show controller t1 or show controller e1 command and specify the port number:
5300# show controller t1 0
T1 0 is up.
No alarms detected.
Framing is ESF, Line Code is AMI, Clock Source is Line Primary.
Version info of slot 2:
Data in current interval (476 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
HW: 2, Firmware: 14, NEAT PLD: 13, NR Bus PLD: 19
Purpose
Enter enable mode (also called
privileged EXEC mode).
Enter the password.
You have entered enable mode when the
prompt changes to
.
5300#
Enter global configuration mode. You
have entered global configuration mode
when the prompt changes to
5300(config)#.
Enter controller configuration mode to
configure your controller port. The
controller ports are labeled 0 to 3 on
Quad cards and 0 to 7 on Octal cards.
Enter your telco's framing type.
Enter your telco's line code type.
Repeat Step 3 to 5 to configure each
additional controller (there are 4 in Quad
cards and 8 in Octal cards).
Return to enable mode.
This message is normal and does not
indicate an error.
Advertisement
Table of Contents
