Verify - Cisco AS5300-96VOIP-A Software Configuration Manual

Configuring T1 CAS for VoIP
Table 3-23
Step
7
8
9
10
11
12

Verify

•
•
3-42 Cisco AS5300 Universal Access Server Software Configuration Guide
Configuring Service Provider T1 CAS (Continued)
Command
5300(config-controller)# dial-peer voice 3070 pots
destination-pattern +30...
port 0:1
prefix 30
5300(config-controller)# dial-peer voice 4080 pots
destination-pattern +40...
direct-inward-dial
port 1:1
prefix 40
5300(config-controller)# dial-peer voice 1050 pots
destination-pattern +10...
direct-inward-dial
prefix 50
5300(config-controller)# dial-peer voice 2060 pots
destination-pattern +20...
direct-inward-dial
prefix 60
5300(config-controller)# dial-peer voice 5050 voip
answer-address 10...
destination-pattern +50...
5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
To verify your controller is up and running and no alarms have been reported, enter the show
controller t1 or show controller e1 command and specify the port number.
5300# sh cont t1 2
T1 2 is up.
No alarms detected.
Version info of slot 0:
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x42,
Board Hardware Version 1.0, Item Number 73-2217-4,
Board Revision A0, Serial Number 06467665,
PLD/ISP Version 0.0, Manufacture Date 14-Nov-1997.
Framing is ESF, Line Code is B8ZS, Clock Source is Internal.
Data in current interval (269 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
To check the validity of your dial peer configuration, enter the show dial-peer voice command
to verify that the data is configured correctly. Note that you should use this command only if you
have relatively few dial peers configured.
5300# sh dial-peer voice 4
VoiceEncapPeer4
tag = 4, destination-pattern = `+4....',
answer-address = `',
group = 4, Admin state is up, Operation state is up
incoming called-number = `', connections/maximum = 0/unlimited
HW: 2, Firmware: 16, PLD Rev: 0
Purpose
Enter the dial peer configuration mode to
configure a POTS peer.
Specify destination pattern for this POTS
peer.
Specify destination pattern, and direct
inward dial for each POTS peer.
Specify the destination pattern and the
direct inward dial for the dial peer.
Specify the destination pattern and the
direct inward dial for the dial peer.
Specify destination pattern, and direct
inward dial for each VoIP peer.
Return to enable mode.
This message is normal and does not
indicate an error.